more

 

another

 

who would do this?

 

Nacho?

 

customer said the tub drained slow. wonder why....:laughing:

 

What?? I was tired of laying under that freaking house. I needed one more 45 and didnt want to crawl out again so I made one. Whats wrong with it?

 

Now that's just precious. :thumbsup:

Thanks for the Saturday morning chuckle.

 

:laughing:

 

That belongs in a hall of fame somewhere, I hear all the time from these hillbillies, " plumbin, oh I can do plumbin":laughing:

 

Everybody knows you cut the ends at matching angles and duct tape them together.

 

In the defense of who ever did this, it would have be an all most impossible job my your self. It was so tight under the house I had to use a military shovel sometimes to dig a tunnel jus so I could keep going.

 

Outstanding...
Some of the best I have ever seen! :thumbup:

:laughinglaughing:

 

Weak Sauce

 

That looks like some solid Rural Indiana Plumbing there. :laughing::laughing:

 

Good one.

Bad part that would pass for good rural Indiana plumbing

 

Geez! I could do better than that after consuming large quantities of vodka tonics:yes: I wonder who the plumbing inspector was!

 

Apparently it was never inspected, because the hack who did it wasn't able to apply for and recieve a permit.

 

Will, Good for you, you found extra work.

 

Nice try, but not an origional thought :thumbsup:

 

Nice try, but not an origional thought :thumbsup:

I just love the liberal application of torch heat that was used to accomplish that bend.:thumbup:

It must have smelled great!:laughing:

 

Hey, what's wrong with a little heat bend?. Electricians do it all the time with their conduit!:laughing:

I do it all the time..........................................with copper.

(Schmo should hit it with some white Kilz. :thumbsup

 

That is bonafied. hahaha

 

Nice 45 nh. :no: Guess they ran out of supplies and didn't want to run to blowes.

 

They could've cut a pie piece out, then heated it, and glued it back together......:thumbsup:

 

I can't beat that. The plumbing around here is often of much higher quality. Our jacklegs know that a radiator hose bends a lot easier than that pipe stuff.

 

At least they used primer on the PVC

 

At least it was PVC. I've seen people use rubber hose like a garden hose, barbed fittings and hose clamps for pressurized water distribution. I got the call when the homeowner was sitting in their swamp, I mean living room. Pretty expensive shortcut if you ask me.

 

I believe this may be what you are looking for :thumbsup: