Plumbing Zone - Professional Plumbers Forum banner

1 - 6 of 6 Posts

·
Registered
Pornstar, Service Plumber
Joined
·
5,519 Posts
Discussion Starter #1
Do you guys bother covering the ends?

Years ago we ran a 1" poly line in a trench. When we went to turn the water on the check on the tank tee clogged. It was three dead mice. VOMIT.

After that my boss became very strict about taping the ends of coil pipe.
 
  • Like
Reactions: MACPLUMB777

·
Reverend, R.S.E., Master Plumber
Joined
·
1,083 Posts
I mostly use 1/2” and 3/4”, I buy it as I need it. If I store it, I’ll tape the ends to keep the crud out.
 

·
Registered
Joined
·
10,065 Posts
I mostly dont cap the ends,,but 150 psi of air blows out anything hiding in the coil before putting it on the truck..
 
1 - 6 of 6 Posts
Top