Plumbing Zone - Professional Plumbers Forum banner

Moen kitchen sink faucets

33780 Views 23 Replies 16 Participants Last post by  Richard Hilliard
Moen has at least 2 different size mounting nuts & an installation tool that comes with the new faucets, does anyone know the size of these nuts, or an alternative tool
to remove the faucet other then cutting out with a Dremel?
21 - 24 of 24 Posts
wow, paying for a moen wrench, thats a new one. I carry the dual and single nut moen wrench. Jam a 1/2 drive socket in the dual wrench and use a speed wrench on the single. Got both nuts covered.
PASCO make a tool called the "Nutcracker" which removes lock nuts from half inch shanks. Works great.
I had a Moen nut that actually broke the tool it was so stubborn.

Solution? 5/8" deep sparkplug socket on an extension with a 3/8" ratchet. Came out easy-peasy.
I believe they are 5/8 and 9/16
21 - 24 of 24 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top