Plumbing Zone - Professional Plumbers Forum banner

Moen kitchen sink faucets

33781 Views 23 Replies 16 Participants Last post by  Richard Hilliard
Moen has at least 2 different size mounting nuts & an installation tool that comes with the new faucets, does anyone know the size of these nuts, or an alternative tool
to remove the faucet other then cutting out with a Dremel?
1 - 2 of 24 Posts
I remember using a 5/8" junior wrench on one of the last ones I've installed - before they changed to the three-screw-nut.

If you're in a pinch, a basin wrench will close up tight on that nut.
I had a Moen nut that actually broke the tool it was so stubborn.

Solution? 5/8" deep sparkplug socket on an extension with a 3/8" ratchet. Came out easy-peasy.
1 - 2 of 24 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.