Plumbing Zone - Professional Plumbers Forum banner
1 - 12 of 12 Posts

·
٩(͡๏̯͡๏)۶&#
Joined
·
8,329 Posts

·
Banned
Joined
·
8,808 Posts
why is it on it's side. JK :laughing:
 

·
Registered
Joined
·
6,326 Posts
Yikes. Someone definitely shopped at the Depot and then did some shabby work. Pro, was that the before picture, or did you just happen to snap that while there for something else?
I once had a guy tell me it was OK to run PVC for both hot and cold, he had been doing it in all his homes he remodeled. I told him you may be doing it, but that doesn't make it right. Another DIY that knew better.
 

·
Registered
Joined
·
1,396 Posts
To help make Protech's pics easier to view, I rotated them to the correct orientation and just slightly sharpened them with Unsharp Mask (makes them just a bit grainy, but I'm working with pre-pinched jpegs, not originals, so what can ya do? Garbage in - garbage out. :D). Here are the corrected pics:

Water Gas Cylinder Boiler
Plumbing fixture Plumbing Gas Toilet Bathroom
 

·
philosopher and statesmen
Joined
·
8,326 Posts
will the insurance company pay up??

I would guess that the home owner installed this mess and it came from home depot...

when the pipe finally snaps off on the cold inlet or it breaks back in the corner where the hot line is under stress, and
completely floods the home,

I wonder if their insurance company will
pay the bill when they see that slop???:no:
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top